Modifying a command
If you are working in the command bar, there are special ways that you can
modify a command as you work. You can modify the active command using any of
the following options:
- Entity snaps Type an entity snap command, such as nearest
or midpoint, to enable a one-time entity snap for a single selection.
You can also use a one-time entity snap to override a running entity snap.
- Extension snaps Type int after selecting a command,
such as Line or Circle, to enable a one-time snap to the logical location
where two entities would intersect if they were of infinite length. Type app
to enable a similar one-time snap if the extensions would not intersect in
three-dimensional space but would intersect in the current view.
- Midpoint snaps Type m2p or mtp to enable
a one-time snap to the midpoint of two points that you specify.